Why is the LED on my T8 / T10 Subwoofer blinking, although everything seems to be set correctly

 

LED CLIP (7) blinking

Cause: Input is overloaded, the signal level is too high.

Reduce the volume and the subwoofer level on your receiver. 

If you have already done this and the clipping LED lights up immediately after Auto On (automatic start after a signal is present), then please contact us.

LED Pairing (16) blinking

Cause: The wireless module integrated in the T8/T10 subwoofer signals by blinking that it has not yet been activated.

Solution: Activate the wireless module. Afterwards, the blinking will also stop in wired operation.

In the Overview: Wireless Subwoofer you can see which devices the T8 and T10 subwoofer can be wirelessly connected to. If you do not have a device that you can wirelessly connect to the subwoofer, feel free to use the Subwoofer Wireless Transmitter.

This is how the one-time activation of the wireless connection works:

1. Slide the INPUT switch (10) to the "WIRELESS" position.
2. Turn on your subwoofer. Hold down the PAIRING button (16) until the STATUS LED (6) blinks rapidly.
3. Turn on your wireless-compatible receiver or the Subwoofer Wireless Transmitter and put it into pairing mode. Exactly how this works can be found in the user manual of your device.
4. When the two devices have connected, the STATUS LED (6) lights up continuously.

 

If you now want to use the subwoofer wired, connect the subwoofer and device (e.g., AV receiver, soundbar, etc.) by cable. Slide the INPUT switch (10) to the "Sub In" position.

 

If you do not have a wireless-compatible receiver or Subwoofer Wireless Transmitter available or the above-mentioned steps do not lead to the desired result, please contact customer support.